Home Products ADP - Interface Relay Adaptors ...24Vac Coil ADP-0241-05A

ADP - 0241 - 05A - (24Vac coil with 120Vac switching up to 5A)

HMI  Interface Relay Adaptors 


HMI  Hoyme ADP- 0241- 05A
This Relay Adaptor may be used as an automatic switch having a 24Vac coil and 120Vac contact points to control a line voltage circuit for a 5 amp draw. i.e. Exhaust Fan. Adaptor can also be used 100% for 24Vac switching (See ADP-1101-05A). Switching 24Vac dampers and thermostat circuits use ADP-0242-05A type only and for 120Vac fan control, use ADP-0241-10A type only.

Installation instructions - Printer friendly (pdf)

Colored Wiring Diagrams used with the ADP-0241-05A
 

#6A6. Vent switch, replacement air - power open, interconnected with exhaust fan, heating cycle and/or cooling cycle  

#6B1. Two Replacement fresh air supply ducts with dampers(Power Open), exhaust fan and Vent Switch

#6C2. Vent switch, replacement air - power open, interconnected with exhaust fan, heating cycle and/or cooling cycle  

#6C3. Vent switch, replacement air - power open, interconnected with exhaust fan, heating cycle and/or cooling cycle  

#6C4. Vent switch, replacement air - power open, interconnected with exhaust fan, heating cycle and/or cooling cycle  

#7. 24VAC vent switch, combustion air, & replacement air 

#7A. 
24Vac vent switch, combustion air, & replacement air with two exhaust fans and two individual timers

#8. 24VAC vent switch & replacement air opens during firing 

#8A. 
24Vac vent switch & replacement air damper Power Open

#8B. 24Vac vent switch with relay, replacement air damper Power Close 

#8B2. Forced Air Furnace with a replacement air supply duct controlled by a fresh air Power Open Damper

#8C. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Closed Damper 

#8C1. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Open Damper 

#8C2. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Open Damper

#8C3. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Open Damper

#8C4. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Open Damper

#8C5. Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air damper with Power Open Damper 

#8C6. Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air damper with Power Close Damper

#8D. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Close Damper

#8D1. 
Two Forced Air Furnaces sharing a replacement air supply duct controlled by one fresh air Power Open Damper

#8D2. 
Forced Air Furnace with a replacement air supply duct controlled by a fresh air Power Open Damper
 
 


ADP-0241-05A

Last Updated (Tuesday, 20 September 2016 09:47)