HMI Hoyme ADP – 0241 – 10A
This Relay Adaptor may be used as an automatic switch having a 24Vac Coil and 120Vac contact points to control a line voltage Circuit for up to a 10 amp draw.
i.e. Exhaust Fan Adaptor can also be used 100% for 24Vac switching (See ADP-1101). Switching 24Vac Dampers and Thermostat Circuits use 5A type only (ADP-0241-05A) and for 120Vac Fan control, use 10A type only (ADP-0241-10A).
Installation Instructions – Printer friendly (pdf)
Wiring Diagrams used with the ADP-0241-10A:
- #7A1. Two 24vac Ventilation Switches/Timers and Two Exhaust Fans, Combustion Air Damper (HOM-0x11-SF1), One Adaptor (ADP-0241-10A) and 7 pole connector, One Power Close Replacement Air Damper (HAC-0x10-OPC). Also Turns On Inlet Fan.
- #8A1. One 24vac Ventilation Switch, One Adaptor (ADP-0241-05A), One Power Open Replacement Air Damper (-PO) Does Not Open During Furnace Firing and Turns On 120vac Fan.
- #8B1. Forced Air Furnace With Power Close Replacement Air Damper (HAC-0x11-OPC) c/w Relay and a Ventilation Switch that uses Adaptor (ADP-0241-10A) to Ventilate and Also Open During Furnace Firing.
